header
CART IS EMPTY
  » Open Drives
  » Closed Drives
  » Belt Guards
  » Belts
  » Clutches
  » Trans & Rear Pulleys
  » GMA Brakes & Controls
  » Accessories
  » Replacement Parts
  » Install Guides & Warranties
  » About Us
  » Jamar Performance Products
  » Belt Drives, LTD Home
  » BDL
  » GMA
GMA BB-5 INVERTED FLARE FITTING KIT
1141 GMA BB-5 INVERTED FLARE FITTING KIT
ECP-100 ARAMID FIBERS CLUTCH PLATE
ECP-100 ECP-100 ARAMID FIBERS CLUTCH PLATE
OIL FILTER FOR BDL OPEN DRIVE KITS WITH OIL FILTERS (FRAM PH6022)
OF-1 OIL FILTER FOR BDL OPEN DRIVE KITS WITH OIL FILTERS (FRAM PH6022)
Home > Install Guides & Warranties > No Belts Covered Under Warranty
 
No Belts Covered Under Warranty

Why?

  1. We do not manufacture any belts.
  2. Improper handling of belt, twisting, pinching or prying during installation.
  3. Improper belt alignment, toe in or toe out, chamber tilt left or tilt right, vehicle alignment early model FXR's, FXD's, FLT's.
  4. Improper belt tension: too tight, too loose.
  5. Worn out pulleys not replaced at time of belt replacement.
  6. Oil leaks that cause oil to penetrate belt, chemical reaction to rubber.
  7. Air suspensions that cause improper belt tension/alignment, raising or lowering the bike by air or broken shocks.
  8. Failure to properly readjust new belt as it seats into pulleys at 500 and 1000 miles, and at regular services.
  9. Road debris, rocks, metal, glass, tire tread or retread pieces, etc.
  10. Failure to properly readjust belt on bikes overloaded for long trips.
  11. Harsh chemicals used to clean motorcycle, chemical reaction to rubber.
  12. Racing, burnouts, wheel stands, all affect tension and alignment.
  13. Worn or broken pulley isolator rubber/s.
  14. Reverse over bending of belt.
  15. Belt that rubs or has constant contact with upper belt passage way portion of inner primary housing, motorplate or starter pinion gear, lowered bikes.
 
Belt Drives LTD. 505 W. Lambert Rd., Brea, CA 92821 PH: 714.693.1313 FAX: 714.693.1616
Site Design by Momentum